Tutorial of Autool BT360 automotive battery tester

AUTOOL BT360 Car Battery Load Tester is dedicatedly developed to test 12V regular flooded, automotive lead-acid batteries, AGM flat plate, AGM spiral, GEL, and EFB batteries. It provides techs or DTYer with a quick, simple, and cost-effective solution to better know the battery’s charging status, check the battery’s health, and detect faults.

1.Connect the red clip to the positive and the black clip to the negative.  

2.Enter the language setting page after turning on the tester and choose the language you need.

3.Choose the battery test operation status and the correct type of your battery.

4.Set the right parameters for your battery.

5.Press the ENT key as confirmation, start testing. 

6.Test result display for this battery testing.

7.Press the ENT key to start the battery cranking test.

8.Start the car. The test starts after the device detects the car is started.

9.The result display for the battery cranking test.

10.Press the ENT key question if start the battery charging test or not. Press the ENT Key again to start the battery charging test. The device will give the notice to increase car rotation speed.

11.Increase car rotate speed to 3000r/min, keep this speed for 5 seconds. The device automatically starts the charging test.Test result display for charging test.

For more detailed tutorials, please subscribe to our YouTube channel.

 

Leave a Reply

Your email address will not be published. Required fields are marked *